Type S Thermocouple - Technical Information
Type S - Platinum-10% Rhodium vs Platinum, IEC 60584-1
Thermocouple Type S can be used in oxidising or inert atmospheres continuously at temperatures up to 1600°C and for brief periods up to 1700°C. For high temperature work, insulators and sheaths made from high purity recrystallised alumina are used. In fact, in all but the cleanest of applications, the device needs protection in the form of an impervious sheath since small quantities of metallic vapour can cause deterioration and a reduction in the EMF generated.
Continuous use at high temperatures also causes degradation, and there is the possibility of diffusion of rhodium into the pure platinum conductor - leading to a reduction in output.
Type S Thermocouples - Typical Constructions and StylesType S Mineral Insulated
Thermocouples Rugged sensors, ideal for most applications. Vast choice of terminations e.g. pot seals, cables, connectors, heads etc. Type S Thermocouples for use in Vacuum Applications Ceramic sheathed calibrated thermocouples designed specifically in vacuum furnace applications with very low leak rates Type S Miniature
Thermocouples Ideal for precision temperature measurements where minimal displacement and a fast response is required. Type S Heavy Duty
Thermocouples For industrial applications such as furnaces, kilns, ovens, boliers, flues etc. Many types of sheath material available. ATEX/IECEx Approved
Type S Thermocouples A large range of thermocouples with a variety of terminations such as pot seal, terminal heads etc.
Type S - Technical Data
|Conductor Combination||Approximate generated
EMF change in µV
per ºC change
(referenced to 0ºC) at:
|Thermocouple Output Tolerances|
to IEC 60584-1
|+ Leg||- Leg||100ºC||500ºC||1000ºC||Continuous||Short Term||Type||Class 1||Class 2||Class 3|
||8||9||11||0 to +1550ºC||-50 to +1750ºC||Temperature Range
|0°C to +1100°C
1100°C to 1600°C
±(1 +0.003 (t ⋅ 1100)°C
|0°C to +600°C
600°C to 1600°C
±0.0025 ⋅ [t]
2. Thermocouple materials are normally supplied to meet the tolerances specified in the table for temperatures above –40 deg C. These materials however, may not fall within the tolerances for low temperatures given under Class 3 for Types T, E and K thermocouples. If thermocouples are required to meet limits of Class 3, as well as those of Class 1 and/or Class 2, the purchaser should state this, as selection of materials is usually required.
Cable Colour Codes S Type Thermocouple
|ANSI/MC96.1||IEC 60584-3||Redundant national colour coding for thermocouple cables|
|BS 1843||DIN 43714||NFC 42324|